I’ve had good luck with LG buying new.
If I didn’t care about anything fancy, I’d probably talk to the local repair shop that refurbishes old units and sells them on the cheap with their own warranty.
I’ve had good luck with LG buying new.
If I didn’t care about anything fancy, I’d probably talk to the local repair shop that refurbishes old units and sells them on the cheap with their own warranty.
Fun story the motor in every dryer that turns the drum is made by the same company.
Also, anything except for samsung.
2nd fun fact. Microwaves are all made by the same company too.
That'a not quite true. Microwave components are made by one of about three manufacturers, which is slightly better but not by much. Sharp, LG, and Panasonic to my knowledge.
True. Panasonic “inverter” microwaves are still Panasonic though, I think.
Also, Refrigeration is Midea, Daikin, and a handful of others in very limited applications; some American made AC, Mitsubishi heat pumps, Liebherr refrigerators.
Tv and computer panels are similar - I think it’s LG, Samsung, and one or two Chinese companies in the market. That Dell display? The Apple display? Probably LG.
I actually don’t hate my Samsung washer/dryer all in one unit but at the same time I don’t blame anyone for avoiding that brand like their lives depended on it.
OP: Where are you located? I can imagine the EU market being different than, say, the eastern Asian market.
I live in the EU, and the top brands appear to be Miele (although quite expensive) and Bosch / Siemens (better bang for buck). I have a Bosch dryer that has lasted almost a quarter century and is still going strong. My current washing machine is a 15 year old LG, so I am happy with the bang/buck ratio there. I did have the motor replaced though at one time, so that is a bit of a cheat.
My previous wash & dryer were LG, and lasted probably about 15 years. We replaced them with new LG ones, and they seem to be largely about the same build quality. We've only had them for about a year, so I can't say for certain, but so far no issues.
They do have IoT features, they're optional though and would work fine without hooking them up to the internet. If you do have smart speakers and such, it is kind of nice to have them let you know when they're done running because we can't hear them go off in the basement from upstairs.
We also sprung for the pedestal washer, which has been great. I was skeptical about it but I find myself using it a lot for when you have just a couple things that have special washing instructions or just a bit more than you can fit in the main washer. It's also nice having the washer and dryer being a little higher to load/unload, and the pedestal drawer under the dryer is nice for storing detergent and such.
I like pro-consumer initiatives like this one: https://ledger.worseonpurpose.com/
Here's a direct link to brands in the Appliance category for your convenience.
If not premium speed queen, then LG base models are best bang for buck I could find in terms of reliability.
Not Samsung, they're fancy, expensive trash. Not Whirlpool or Whirlpool brands, unless you want to replace 2 years 1 month (to the day) of purchase. I'm in a similar boat as you.
Edit. 2 years 1 month, by the way, is 1 month past the manufacturer's warranty, which is trash anyway.
Amana makes simple, reliable machines without any of the WiFi connected bullshit. We've had ours for the last 8.5 years and only had to replace a dryer belt earlier this year.
My parents bought an LG washer about 6 years ago thats still working fine. (They're still using their Maytag dryer from the mid 90's) No issues with it. It has some IoT stuff, but you can just not connect it to any network and it still works. The advice they received when they were shopping around was "anything but Samsung"
We have a pair of Maytags from the 1980s. One we got used off Marketplace, the other was sitting in the backyard for a few years and just needed some new parts. Still going strong. 40+ years. They don't make them like that anymore.
My In-laws have speed queens and they are the loudest and jankiest washer and dryer I have ever seen. And they have had to have them serviced as much as my 10 year old Samsung set and they are only a couple of years old.
Find a local appliance repair shop that you trust, and ask them which ones are easiest and fastest to service. Speed Queen may be more reliable in laundromats where they can be fine with one washer down for a month, but at home you only have one, and anything more than a 3 day wait time is impractical. Therefore your best value is going to be whichever model can be brought back to operation the fastest without breaking bank.
You can get used commercial speed queens for a similar price as new consumer units.
The nice thing is the commercial units are designed to be maintainable. Parts are available, and they're designed to run for years in rough environments.
Honestly, I suggest to keep the settings/options basic and don't buy the cheapest units.
I have a Samsung pair in 2010 from before they shit the bed and have been happy.
With that said, I have replaced a water pump (year 2) and water-inlet solenoid valve (year 15)... then a dryer belt (year 13) and gas-inlet solenoid valve (year 15). Fingers crossed and thanks to all the youtube videos for keeping them running.
It might be the humid climate here in the SE US, but everyone i know with a front loader has mildew problems. Tablets, coatings, sani cycles- all band-aids for inherent design problems.
I've gone through a number of machines in the past 15-20 years as I've had to move a bit (not moving machines).
My least favorite were any of the front loaders I've had. They washed ok, but the big front gasket always got gross and demanded frequent wiping/drying and you had to leave the door open or it would get mildew. One of them (electrolux) would frequently refuse to run the spin cycle. I had to learn the secret button combination to force a spin cycle. It also had a drain filter that was meant to catch lint and junk. It was only accessable if you tipped the machine over as the access was from underneath the machine. Terrible design.
I had another front loader, and it wasn't as bad, but still mouldy gasket and stinky laundry from time to time. If you forgot and left a load in overnight, it was fetid. I became aware that using vinegar was very effective to de-stink towels that always had a stinky odor about them. Needed to do it a few times a year.
I had a cheap set of whirlpools for about two years, they were fine, but at that age, they should be.
Moved into a house with a fancy set of whirlpools, wifi and all that junk. Never used the app stuff, but the washer self-destructed about three years after I moved in. I don't think they were very old when we got here. Some metal plate that the wash drum sat on, cracked and during a spin cycle it shattered making a horrible noise and that was that. Did not even bother trying to fix it.
I have a speed queen washer now and a bobo free gas dryer my brother gave me. Washer has been fine for about three years, no issues, washes a full load in 30 min. Very few options, it's the basic model. The dryer shat a belt which I fixed with an accessory belt from a Chevy Trailblazer that I cut to be thin enough. Claude helped me find a belt that was the right length, who says AI is useless?
My wife's grandmother had THE cheapest washer from home depot, I think it was branded as a Roper or something. It never had issues.
Some of my friends have LG machines. In both cases, there is a little flap on the front you are supposed to open and a hose with a plug inside. They say you have to pull the plug and drain the excess water after each load or the machine will stink. You also have to leave the door open. This seems like a lousy design.
If buying new id get one of the larger heat pump units that also dries. Get all that space back from having a dryer.
I talked to an appliance repair guy recently about the longevity of washers and he said the front-load tended to last longer, for whatever that’s worth.
Huh, that's interesting. I was anticipating what you were going to say until the end. That's kinda surprising, but I guess if I saw blue prints, or took one of each apart to see how the mechanisms work, it might make sense. I've just never really bothered or had a chance.
Used to be the opposite was the case. But I suspect residential front loads have been around long enough to work most of the kinks out. And, if the tub seal fails in a top load, theres a good chance you have to replace ths entire drive mechanism which is like 40% of the cost of a new washer.
Look up reviews. It's more the model than the brand.
Typically the best return on your dollar is mid tier models, but not always.
Cost/energy per load is something they test for with consumer reports. typically the oversize loads are cheaper.
I have a double washer and I love it. It did fail a few months after I got it, but was repaired under warranty and has been worth for 6 years w/o issue since. a Samsung
Speed queen is junk from the 1960s. Incredibly inefficient and fairly ineffective. Top loaders are a joke.
Miele is modern top end. Bosch is also quite good. Cheaper too.
I have an LG. It is positively violent.
Everyone's dumping on Samsung. I will say, I will never buy a Samsung fridge again.
I have a Samsung top loader washer and front loader Dryer purchased in May 2022.
Aside from a couple issues with the washer experiencing an unblance problem, they've been great.
I will avoid buying a dryer with the "hinged" lint trap in the future. That's honestly my only beef. The dryer sensor is useless too, I set most things to the "bedding" setting, because otherwise a third of the laundry comes out a little damp.
all 44 comments