My understanding is that most roller blind tubes are hollow, so it’s just a case of buying a bound motor that sits inside them. There are also some that pull the beaded rope thingy but I’ve never used those
I have a zigbee2mqtt set up already, using a SLZB-06. Blinds worked fine with it, no fiddling required
I have used the zemismart ones. Essentially one end fits into the cross of the bracket and holds the frame. The motor inside the tube turns the small piece inside the tube.
In essence, the blind tube rotates around the blue tube you can see.
I thought that. It was a fresh roll of elegoo PETG, had silica in and vacuum sealed. More than one print failed in this way too.
I should say, I have so far changed to scarf joints, changed to normal z-hop and increased a-hop height.
I also increased brim size, even though I had no evidence of lifting.
I recently replaced my aging but well dialled in FLSun Q5 with an Elegoo CC2.
I am very pleased at being able to print much larger things, but I get this effect at height. This is an egregious example but even cleaner prints still have obvious layer shifts.
I’m just admiring your nut case!
I like what you’ve got and will give it a go. I’m following a trail that started with an iOS app for helping you keep track of when you last contacted your friends. I couldn’t see that in your screenshots, but it would be a great feature for me at least!
I only found out about Monica from one of the ADHD communities, and when I looked there has been. No update for almost a year. I thought it might be dead?
Was excited to explore this, but project looks stale?
Never tried this, but it was in a selfh.st newsletter a few weeks back
https://www.dedicatedcode.com/projects/reitti/?ref=selfh.st
I thought I would try it out when I had time. It does ‘memories’ and seems to tell a story about your data.
Depending on your level of technical skill and willingness to risk crack things open, you can flash most Tasmota type devices with esphome and hard code it to be always on. This would go along way to eliminating software as the problem. I have done this with meters attached to my washing machine and dishwasher.
Also, the boards are also relatively simple and it is likely (although there are lots of variants) that you could remove the relay completely and bridge across the terminals. I wouldn’t plug my electric car into it (10A sustained) but you could put a led lamp through it without without much risk.
Disclaimer - I am a hobbyist, not an electrician. YMMV, keep a fire extinguisher nearby, yadda yadda
Hrm… when I am with my family (brothers and Sisters) our conversations are like this. Our partners find it a bit weird/intense/think we are always fighting but we think that’s just how it works…