37
What could be causing this on my new Elegoo CC2? (lemmy.world)
submitted 4 months ago by to c/3dprinting@lemmy.world
12 comments fedilink hide all child comments
 

I recently replaced my aging but well dialled in FLSun Q5 with an Elegoo CC2.

I am very pleased at being able to print much larger things, but I get this effect at height. This is an egregious example but even cleaner prints still have obvious layer shifts.

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 6 points 4 months ago (1 child)

I should say, I have so far changed to scarf joints, changed to normal z-hop and increased a-hop height.

I also increased brim size, even though I had no evidence of lifting.

  • permalink
  • fedilink
  • source
  • hideshow 1 child comment
    •
  • [–] 4 points 4 months ago

    Just seeing this. If you really think this isn't warping print a cylinder tower in the spot where this parts messed up edge was on the bed. If that prints with an issue in the same exact height, it's a problem with your mechanisms, likely z axis.

  • permalink
  • fedilink
  • source
  • parent