How quickly can these remove the valve? could you cut off the stem with wirecutters faster?

How does it go when you remove them from a fully pressurized tire? I have only ever removed cores when the tire was empty or had a low amount of pressure.

If the ICE vehicles don't have wheels, they can't move very fast...

Battery powered impact driver plus a deep socket set = you can remove lug nuts or bolts (securing a wheel to a vehicle) in very quick fashion.

Here's a compact socket set that will handle most every consumer vehicle too: https://www.amazon.com/dp/B00EHK86WS.

Almost the same one at HF where you can pay cash: https://www.harborfreight.com/12-in-drive-impact-flip-socket-set-3-piece-62491.html

5 lug nuts can be loosened in about 5 seconds with a heavy duty impact wrench. If you've ever seen tires get stolen it only takes about 15 seconds to pull off.

That will be enough to disable the car. It'll get moving before they notice it.

Make sure the battery is at full charge. Chevy typically uses 12mm or 14mm lug nuts in their trucks.

Used motor oil and sand in a water balloon also completely obstructs the view through any window and can't be cleaned off.

Also don't forget your locking nut key for those pesky lock nuts

Leaving only those will make for a bigger surprise a few minutes later when they take a corner at speed. Or hit a bump.

If only one is locking just break the others. Locking will break in short order.

Why use it on the vehicle and not the ICE agents? Rip their sacks right off with 2500 lbs of torque.

Fucking with the brakes risks getting bystanders involved, though.