[–] 4 points 2 months ago*

For my Kobo I've mostly used Anna's Archive and then converted epub from there into kepub format with Calibre; just need to rename the file to the epub file extension afterward (I usually keep both like My book.kepub.epub for my own reference).

Edit: MyAnonaMouse is indeed a great community as others have said though I found their selection to not be as good though that might be biased to the topics I prefer to read.

  • source
  • [–] [S] 1 point 5 months ago

    Update: wire arrived today and it was NOT a match. The X Limit Switch wire has a white label with an X and while 1 end is correct the other is wrong. Creality support did eventually get back with me and said it was the cutter detection cable with SKU 3103110734 so guess I'm set back another 3 weeks ordering the other wire variations from DREMC. In hind sight I should have gone ahead and ordered 1 of each to be sure; oh well.

  • source
  • parent
  • context
  • [–] [S] 2 points 6 months ago

    Creality store support said they don't have the part and directed to main Creality support email

    Creality support email said to try Amazon, Alibaba or Aliexpress - no luck on any of those

    Ordered a replacement from a site in Australia (only place I've found so far that carries it) and will likely attempt to repair the wire while I wait for it to arrive

  • source
  • [–] [S] 7 points 6 months ago* (last edited 5 months ago) (1 child)

    I think that's the one! Mine even has the "D" printed on the white sleeve like that one has. Thank you!!

    Creality Hi Series Filament/Cutter Sensor/X Limit Switch Wiring
    SKU: 3103080144
    https://store.dremc.com.au/en-us/products/creality-hi-series-filament-sensor-wiring?variant=46843602665641

    This is the only online store I've found so far that carries it. Will wait for support email to reply to see if they'll supply it.

    SEE UPDATE IN MAIN POST

  • source
  • parent
  • context
  •  

    While removing the extruder on my Creality Hi to clear a jam I damaged the wire that connects the extruder board to the print board and I have NO IDEA where to purchase a replacement wire.

    It's a 3pin wire roughly 9cm long with 2 male ends where 1 is about 2mm wide and other about 5mm wide.

    MUCH appreciate any advice on where to shop and what search terms to use for locating a replacement, ideally located in the US.

    UPDATE

    After some trial and error did confirm the part number as 3103110734 Cutter Detector Wire and thanks to Creality forum thread found the wire and tip specs to be:

    JST GH 1.25mm Pitch - locking type 3 Wire & SHR-03V-S-BSH 1.mm Pitch 3 Wire
    The cables are 28: AWG, ~100mm Cable Length

    Ended up just buying one off eBay for $15 shipped rather than attempt to make my own. Creality support did offer to sell one for $5 but with $30 shipping...

    view more: next ›