How do you get the cheap shit here again?
Error persists on entire layer where a new retraction pattern is used, therefore it is very unlikely to be filament humidity or a gcode issue, but filament settings.
What is your retraction length and speed? Do a cold pull to rule out debris. Reduce your retraction until stringing occures, observe if the error repeats. Temperature could be playing a role, but if your layer adhesion is up to expectations, I wouldn't change. Also observe your nozzle and make sure it's taught, I've been surprised how fast some of my brass nozzles have worn out even with non-abrasives, and causes a similar symptom of randomhish failures, especially if loose.
PS: sometimes a couple cold pulls are needed and try to hit different temps when you pull. I've noticed since PETG doesnt stick to PLA, to use PLA as a cold pull you actually need it warm enough that the PETG bits will flake off the inside
I'm going to remain cautiously optimisic, they have a lot of the original SG-1 and Atlantis writers and team, as well as some of the crew associated to the movies. But to be honest I'm scared, and 10 episode seasons is already a taste for amazons poor management.
(I won't get over the SIX episodes for the final season of the Expanse, which I'd still consider a content quality win as far as amazon is involved)
Love me some quick swaps, I'll probably be checking one out eventually. I like Prusa's mozzle design, but they're flippin expensive for hardened, and torquing the adapter to a standard mozzle has been a certified PITA
Is the nozzle change proceedure as intensive as I hear? I've got a prusa mini and xl, as well as some modded ender 5 and 3, but I'm brand agnostic in expanding my fleet
That's so funny, never been around playstation much but I could've also sworn they were called dualshock. Bernstein bears or whatever 😅