I always viewed 12-tone as more of a mathematics exercise than anything.
This is done intentionally, and repeats further throughout the installation. The main reason is it prevents long runs of grout lines. The installation will be stronger, and there’s no need for an expansion joint. Additionally, it’s harder to see if the grout joint shifts one direction or the other over a long run.
I don’t think it need to be done every fifth tile though- that’s a design choice by the installer.
I think everything in this image makes sense. Also, the oldest version I can find online is 4 years old, making it very unlikely to be AI.
Looks great so far! I used to do these kits a long time ago and always had great results. The only thing I would change is the yeast, but I don’t think that was really necessary.
This did it! Thank you! I actually found this page and did the first half, not realizing there was more. I'm not confident I installed the exact correct driver, but I have dual screens in the proper resolution. This should get me by while I troubleshoot everything else.
Thanks again!
I actually disagree with this, only because the flooring is tile, not LVP. Tile can be installed in this pattern, and it is actually recommended to have no more than a 33% overlap with rectangular tiles to prevent slippage in installation.
To correct any misinformation in this post- what you have is porcelain tile installed very, very poorly. You can install tile in this pattern- it is not an issue with tile. However, what’s underneath is very concerning. I have never seen that much mortar used.
You need to get a professional in, even if to look at it and give advice. My guess is if they used that much mortar, it would all need to come out and actual cement board would be needed as a base to bring the flooring to the appropriate height.
This is 100% porcelain tile. I worked in a tile factory- there’s no mistaking it.
Wow. That looks fucking terrible.