🫠

If you change materials as much as I do you are treated to a clog often enough that I can say my extruder is clean. 🤓

Particularly important if you expect to be on the receiving end of a butt play session.

I refuse to use any extruder without easily accessible gears anymore, for that exact reason lol. Using a Galileo2 on a Stealthburner I'd get flexible filaments wrapped around the gears alllll the time, and disassembling it was super annoying. Now it's wristwatch style all the way!

I had the extruder in my Qidi apart just last night because I had the tip of a piece of ABS snap off inside during a filament change. I found a bunch of dust presumably from various instances of filament grinding from the last few months, probably due to e.g. running the hotend at the wrong temperature for the filament due to being a dummy. It happens occasionally.

It's not too tough to access on my machine but one of these years I will remember that you need to drop the heater block assembly out first, and then remove the gear cover. Just... not this time.