my 3d printed mouse broke - the click upper didn't up anymore. With a new 3d printed part, the click upper now ups again.

all 16 comments

sorted by: hot top controversial new old
[–] 31 points 4 months ago (1 child)

i was going to say "great, now clean it"

but then i looked at my mouse

so, good job!

  • source
  • hideshow 1 child comment
  • [–] 20 points 4 months ago* (5 children)

    Is the red stuff 3D printed?

  • source
  • hideshow 5 child comments
  • [–] [S] 24 points 4 months ago (4 children)

    Everything except the circuit board is 3d printed

  • source
  • parent
  • hideshow 4 child comments
  • [–] 11 points 4 months ago* (3 children)

    Wow that's brilliant! I guess it's some sort of standard circuit board?

    Also it's too hot here, 3D printed is in the title, sorry 🤪

  • source
  • parent
  • hideshow 3 child comments
  • [–] [S] 14 points 4 months ago (2 children)

    No, it's a one-off circuit board. It's open source as well. You can make it yourself.

  • source
  • parent
  • hideshow 2 child comments
  • [–] 12 points 4 months ago (3 children)
  • [–] [S] 29 points 4 months ago (2 children)
  • [–] 11 points 4 months ago

    You needed new brake pads?

  • source
  • [–] 5 points 4 months ago

    Fixed my mouse today

    Can't close my eyes, or make it go away.

  • source
  • [–] 3 points 4 months ago (1 child)

    My MX master 2 is starting to die, how are your experiences with this mouse? Aren't the layer lines a annoying texture?

  • source
  • hideshow 1 child comment