539
Anti Facial Recognition DIY (lemmy.ml)
submitted 1 year ago by to c/funny@sh.itjust.works
58 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] 1 point 1 year ago (4 children)

But where did the bottom piece come from? It has tiny holes all over and i cant picture any part of the case that has that contour. And its never shown in any other pic

  • permalink
  • fedilink
  • source
  • hideshow 4 child comments
    •
  • [–] 2 points 1 year ago (2 children)

    Bottom of the mask is the part cut out in the top right picture. It comes from the slope on the top back part of the monitor.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 2 points 1 year ago (1 child)

    No the top right is clearly one of the face pieces, you can even see where half the eyehole is cut. It also has a large portion without the little holes in it just like the face pieces.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •
  • [–] 1 point 1 year ago

    You're right, I clearly didn't look at it close enough.
    However, I think I am correct for the source of the material. Now that I look closer I'm pretty sure that the top right picture is actually of the monitor turned on its side. And then he would have taken the matching cut from the other side of the monitor for the other side of the mask.

  • permalink
  • fedilink
  • source
  • parent