18
FYI (opinion.) don't buy an MMU (sopuli.xyz)
submitted 1 year ago by to c/3dprinting@lemmy.world
29 comments fedilink hide all child comments
 

Most of the multi color printers out there are AMS/MMU or similar, and there are many DIY options, like Armored Turtle or ECF.

They are an evolutionary dead end. Slow, wasteful, expensive to run.

The Prusa XL, or the Snapmaker U1 are the future direction.

Also a good CoreXY machine like vorons/sovols/ratrigs/VZ, etc can be upgraded with the Bondtech INDX tool changer.

We are talking 5x lower print times, 5x lower material costs.

There is going to be a glut of used Bambus and other multi material unit printers, when print farms unload them, since the tool changers will massively boost their bottom line.

Comments?

you are viewing a single comment's thread
view the rest of the comments
[–] 4 points 1 year ago (2 children)

Same here. Printing something like say, a cow, with frequent swaps would be wasteful, but I'll do parts with 1-2 color swaps. It's mostly nice as you said though to have multiples "locked and loaded" to do a 1 filament print.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] [S] 0 points 1 year ago (1 child)

    If you have a print with supports, having a support filament that adds little extra time, compared to an MMU, is much more than nice. Being able to use rigid and flexible prints reliably in the same print is more than nice. From what I have read, flexibles in MMUs are prone to failure.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •
  • [–] 1 point 1 year ago

    So I have a FlashForge AD5X with the MMU. It worked amazing out of the box, including flawlessly doing some TPU. They actually mentioned the MMU was designed with TPU in mind. That being said: I have been struggling with basic PLA, even after swapping to nozzle that has run only PLA (even though I only ran <10g of TPU through it). I am still new to a lot of this, and don't feel experienced enough to fault the hardware. What I can say though is it does seem folks are specifically improving the ability of MMUs to handle flexibles. A big reason I got it was to be able to do ABS parts with TPU gaskets. Ask me in a few months.

  • permalink
  • fedilink
  • source
  • parent