Orca ... buttttt, there is an upcoming massive update to Prusa slicer which might make me switch 🧐

Of course 😄 I was only being silly

Alternative title: "GNOME 51 Beta released, with no major improvement"

/s 😜

Guess we'll just have to wait 😄

Why can't it say what the job is 🧐🧐🧐

I don't think there is really. I haven't even encountered many good Foss launchers except Lawnchair.

[Solved], but what was your solution 👀

Waydroid: a container-based approach to boot a full Android system on GNU/Linux

Zero click here - basically a klicky too! Fantastic if you don't feel like using a build plate.

I cancelled the other objects that were supposed to print after, but left these because I thought any damage would be done already. Luckily, no damage and no waste!

What sort of probe were you using on your ender?

I highly doubt your nozzle is worn out unless you've been printing with any special tough filament (e.g. carbon fibre core). It's completely different machine, but I have over 300 hours on mine and I haven't had to replace the original brass nozzle yet.

Edit: Perhaps try printing a solid section of only the first layer (no need for the whole bed, but make is fairly large). See if the lines mostly all join up, then reprint without changing anything to check if it is consistent.

I found the fuse, but it wasn't blown 🥲 I've looked over the board, and watched some repair videos but I haven't found anything. I've called it dead now.