11
LCP slide: machining the clearance for barrel tilt (forum.guncadindex.com)
submitted 7 months ago by to c/general@forum.guncadindex.com
5 comments fedilink hide all child comments
 

Still can’t get over how much this machine fucks. Running a test cut for this op at what I thought were probably too conservative of feeds and speeds. I stopped it when it seemed like it was too quiet, UGS said 20 hours to complete. Nope. 20 minutes, and I had already cut quite a bit.

Unfortunately… Im an idiot and I fucked up my spring guide hole on the drill press (thin drill wandered quite a bit off centerline at depth). I’ll continue machining this one as I think I can fix it and use it for fitment test, and there will probably be more lessons learned along the way (MAKE SURE YOUR TABLE IS LOCKED SQUARE and you only drill small diameter holes as deep as you absolutely have to).

Ordered more material for take 2 just in case.

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 2 points 7 months ago*

Full slide yes, I want a Holosun on a mouse gun that sits not retardedly high lol and we’ll see if a slide comp makes it a little less snappy.

I did some test cuts with a t slot cutter the right size for the rail slots, as long as I drill the firing pin hole properly and it doesn’t warp when milling out the main pocket for the barrel, we’re good to go. I have a kiln I can use for heat treat, 17-4 heat treat is not complicated.

Not the whole gun, though, and no blueprints, just measuring and an understanding of tolerances

After this I am building a machine that is a pathway to many abilities some consider to be unnatural.

And then I will make a fully DIY 9mm pistol because we really need one. Originally it was going to be a remix I made of the musgres, but it used welding or hard soldering and I’m not sure that’s the way to go if you can just mill rails super easy now.

  • permalink
  • fedilink
  • source
  • parent