1085
Supply and demand (slrpnk.net)
submitted 7 months ago by to c/memes@slrpnk.net
209 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] 4 points 7 months ago (4 children)

Can't you cut the power at each individual solar panel? I assume that the amount of electricity out there is low enough to not cause that kind of problems?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 4 child comments
    •
  • [–] 7 points 7 months ago* (2 children)

    You're pretty much describing what hybrid inverters do for home solar panels. They can disconnect and not export to the grid when you don't need it and just power your house and charge your batteries.

    But hybrid inverters are quite a bit more expensive than standard grid-tied inverters that are always pumping into the grid.

    For instance, I just had to replace my home inverter that died and I got a cheap 6 kilowatt inverter for about $1,300. A hybrid inverter would be at minimum 3 or 4k.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 2 points 7 months ago (1 child)

    Im not that guy, but im picturing moreso just that solar panels come preinstalled with the glass that turns opaque when it recieves voltage. When your batteries are full and the grid isnt pulling power, that would progressively look more and more like either a short citcuit or, more likely, an open circuit. When the voltage rises too much due to na open circuit, the solar panel shuts off by turning the glass opaque, which also adds a load to the battery hopefully trickling its voltage down.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •
  • [–] 2 points 7 months ago*

    Again, that would increase cost significantly. I didn't think of this at first because my array doesn't have RSD because it's older but all new solar arrays in the US and elsewhere have what's called rapid shutdown technology for firefighter safety and it is a device that is mounted to each solar panel and does effectively reduce the output to zero or near zero on each solar panel in the event grid power is lost or somebody hits the rapid shutdown emergency button. So the technology is already in place to do what you're describing but more cost-effective and less elaborate.

    Also, something I should have mentioned is that newer inverters like my own, even though they are grid-tied, can be configured to export nothing and only power the home even without a battery. But the problem with this whole line of thinking is that it would screw over homeowners who should be getting money for the solar they put into the grid, but would be getting nothing in these scenarios.

  • permalink
  • fedilink
  • source
  • parent