24
Old laptop died ๐Ÿฅฒ (lemmy.world)
submitted 1 year ago by to c/askelectronics@discuss.tchncs.de
21 comments fedilink hide all child comments
 

I tried to start my laptop earlier, only for nothing to happen. It won't start on battery or when plugged in (it can run without a battery when plugged in). The battery does seem to be dead, and so is the 3V CMOS battery.

I opened it up and noticed a circle visable on one of the inductors. Hopefully you can see it in the picture.

Could this be the problem, or is that normal?

Update: I've tested some suggestion and watched some repair videos, but I found nothing. Goodbye old friend ๐Ÿฅฒ๐Ÿคš

Thanks for the help guys

you are viewing a single comment's thread
view the rest of the comments
[โ€“] [S] 4 points 1 year ago (5 children)

Thanks. I guess I was just hoping it would be an easy find and fix. The beep confirmed hope is lost ๐Ÿฅฒ

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 5 child comments
    •
  • [โ€“] 3 points 1 year ago (2 children)

    What beep?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [โ€“] 4 points 1 year ago*

    The beep multimeters make when in continuity mode. It is a way to test that 2 points are electrically connected with little/no resistance. If they are connected the multimeter will emit a continuous beep. If there is no beep than either the points aren't connected or there is a resistor or something else preventing the connection. The amount is resistance required to prevent a connection (measured in ohms) tends to be possible to set on the multimeter.

  • permalink
  • fedilink
  • source
  • parent
  • [โ€“] 2 points 1 year ago (1 child)

    Just so you know, as an inductor is just a small coil of copper, the resistivity might be low enough to trigger the beeping on the multimeter! So maybe it's not dead. I've seen a lot of burned down inductor and trust me it looks way worse.

    If your multimeter can measure resistance in miliHoms, you should be able to measure at least ~10mR or more (that order of magnitude) Note that measuring a circuit like so is not guaranteed since there's other stuff on a PCB that gets measured at the same time.

    Did you remove the motherboard and looked at the other side?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •
  • [โ€“] [S] 3 points 1 year ago

    Ah, I realise my wording was very confusing there. I meant: Because the inductor is NOT the problem - I don't have any idea what the problem is - therefore the LAPTOP is dead (not the inductor)๐Ÿ˜‚

  • permalink
  • fedilink
  • source
  • parent