i am building a 3d printed Stargate with lights and sounds using a D1 mini and a DFPlayer mini. The code is from this github repo: (https://github.com/spradlinb/Stargate_3D). when i compile the code in the Arduino IDE i get a SPI error as depicted in the image. I've tried remapping the gpio pins with no success. what am i doing wrong? BTW here is a video of what i'm trying to build: https://youtu.be/y01J-hymaDs

 

I bought a nest gen 2 thermostat to play with a open source project that revives old nest thermostats (https://nolongerevil.com/). Since I don't want to install it into the home, because it will be a toy. I was thinking of building a test rig using a arduino or esp32 to simulate a HVAC and indoor temperature. I'm IT guy, not a HVAC guy, I think this would be a good learning project. Any suggestions?

 

I am going to compile everything i know into this compendium. It will cover the legality and limitations, How to obtain and digitize physical media, how to setup Jellyfin for viewing the content, and explain why owning a copy of a movie or TV show is better than paying for the privilege to access it. I would like any feedback and recommended resources that will help my research.

 

So i built a outdoor hoop antenna to replace my cheap and crapy walmart antenna. IDK if the pre-amp fried the 5g/LTE filter or it wad my diy antenna. Is it possible for a 5g/LTE filter to stop working and filter out every channel. I orderd a new filter to see if it is the problem. Here is the antenna tutorial I followed: https://youtu.be/Tg0JjeotXq4 And the 5g filter: https://a.co/d/gwpNo2g