I don’t remember seeing that before - must be humidity plus MDF trim. Neither wood nor MDF expands significantly from heat. Moisture, on the other hand, makes wood expand across the grain, not along it - so boards get thicker and wider, but not longer. MDF, however, swells in all directions when exposed to moisture. I'm surprised that this is the only piece affected though. Perhaps who installed it forgot to nail in the middle.
post
If it’s warped, you’re going to need a mechanical fastener like a nail or screw.
That's probably too much warping for humidity. The hinges are probably pulling that side of the door lower.
Do you own this property? If so, I would pull the trim off completely, rehang the door properly, with longer screws through the hinges to hold them up to the framing, and then put the trim back on.
If you rent, call your landlord to do the above.
If it’s easy to remove, you can take off the part that’s coming loose, clean off any old glue and dust, then apply some wood glue evenly on the back. Press it back into place and secure it with tape, clamps, or small nails for about 24 hours. Once it’s fully dry, you can fill any gaps with wood filler, sand it smooth, and touch up the paint.
all 9 comments