Slipped a chain, luckly its vietnam so I only had to push the bike down 200 feet of highway and 1 intersection before I found a Honda shop. I'm lucky I wasn't stranded in some mountains or offf-road.

A motorbike with a slipped chain

all 12 comments

sorted by: hot top controversial new old
[–] 9 points 5 months ago

By South East Asian standards, that's as good as new.

  • source
  • [–] 8 points 5 months ago (1 child)

    New sprockets every other chain, and when you clean and lube the chain, check the sprocket for wear. You’re there anyway.

    Should be cleaning/lubricating the chain about every 500mi/800km anyway, and if you check the sprocket when you’re cleaning it, you’ll have plenty of advanced warning.

    Glad you didn’t have to go far and that nothing important (including you) was damaged!

  • source
  • hideshow 1 child comment
  • [–] [S] 7 points 5 months ago

    I have the chain cleaned/lubricated/tensioned every oil change, which is 800km, none of the mechanics mentioned the sprocket, guess I should have inspected myself.

    If the oil change seems shockingly short, bikes in SEA don't have replaceable oil filters, instead you just change the oil every 600-1000km, often with 20w50 or 15w40.

  • source
  • parent
  • [–] 2 points 5 months ago (8 children)

    Isn't this caused by not replacing the chain often enough? It stretches a bit once worn and then can bear more towards the edges of the sprocket.

  • source
  • hideshow 8 child comments
  • [–] 1 point 5 months ago (5 children)

    My owner's manual says to only replace the chain and sprocket together and that only replacing the chain will cause rapid wear.

  • source
  • parent
  • hideshow 5 child comments
  • [–] 1 point 5 months ago (4 children)

    Interesting! I'm coming at this from a cycling perspective where checking your chain for wear is important to reduce wear on the cassette/chainrings (sprockets). There are dedicated tools to measure chains for this reason so it's surprising to me that the same process isn't common in motorcycles. Maybe it's a cost thing? A chain is way cheaper to replace on a bicycle than the multiple sprockets.

    The pins of the chain wear out their bushings over time and the chain then stretches. This means each link won't sit down deep valley between the teeth and wear down the teeth faster due to smaller contact area now acting as the bearing surface.

  • source
  • parent
  • hideshow 4 child comments
  • [–] [S] 1 point 5 months ago (3 children)

    There's only 2 sprockets on a bike, since it uses a geared transmission. I got my chain and sprockets replaced for 18USD, labor included, which I suspect is somehow more than it would cost for a non-single speed bicycle, because bicycles prices are weird.

  • source
  • parent
  • hideshow 3 child comments
  • [–] 2 points 5 months ago (2 children)

    Under $20 explains why nobody worries about it. You could probably extend the life of the sprockets by replacing the chain, but it's not worth the hassle at $20 for a whole new set.

  • source
  • parent
  • hideshow 2 child comments