Leaving coffee on the burner makes it taste worse than reheating it from cold in the microwave. That and a fire hazard is why coffee makers cut off the hot plate so quickly compared to older models.
post
The smarter move is to simply buy a coffee carafe.
This is probably a bad idea, because the timer relay circuit probably has some additional safety features in it such as temperature limits, along with the device never being designed to run indefinitely.
If I had to guess, the heating element is controlled by the relay (big black cube). I would either bypass the output or bypass the input signal. The relay pinout can be easily found online on sites like this.
https://www.alldatasheet.com/datasheet-pdf/view/1133195/SANYOU/SRD-S-112DM.html
It almost certainly is designed to run indefinitely, this exact same coffee maker has been in production since the nineties or so. the only addition is the timer circuit, which is very clearly a much later addition, as the supporting structure is markedly different tk the rest of the device.
Anyway, a 240v switch is in order, I think. Fortunately we still have Farnell here in the UK, I shouldn't like to pay international shipping fees for a single switch from china.
Bridging brown and red or whatever colours not blue and white are will bypass the board entirely.
If that is the only pcb in the device op should be able to just put any (mains capable!) switch there to just toggle the entire device on/off
You're supposed to transfer the coffee to a thermos when 30 minutes is up. The coffee "burns" after that.
I would be furious if the hot plate turned off after 30 minutes lol I thought I had it bad with my coffee pot at work turning off after 2 hours.
Try and find the wiring that connects to the hot plate itself and then work backwards from there
I would rather drink one well made cup of drip coffee followed by the piss that coffee produced, than coffee that's been sat on a hot plate for 30+ minutes.
you and me are different, and that's okay
I appreciate good coffee. I don't care enough to have it on a work day when I just want something hot enough that I don't drink it all immediately and with some caffeine in it because I have a severe caffeine addiction that's developed over years and years that I haven't addressed yet
I will rebrew coffee grounds in my single cup maker because I am that lazy and do not give a fuck about it being shit weak tea that it produces on the third rebrew. my recent upgrade was to using a regular drip machine again and I chose to lower the bean amount to near piss water levels to compensate for the fact that I was previously getting less and less caffeine with each brew whereas now it's just equalized across all cups
there are a couple reasons I drink coffee, and how I drink it is reflected clearly by them:
- caffeine addiction (withdrawal headaches)
- I want to drink something at my desk, and not always just water (I do drink tea sometimes but idk it just doesn't hit the same and I don't like the taste as much once it cools)
I make better coffee backcountry camping than I do at home
yw for the horror story
Wait until you find out there's a lot of people that like burnt cheap coffee.
They're over represented in the "previous military service" and "blue collar shift worker" demographics.
This is what I would do if I'm dedicated enough to this laziness and didn't care about starting a fire in my house:
- The switching voltage is 12V I assume from the datasheet and model number. I'd measure the voltage of the relay (the biggest black box) on the lower side with a multimeter when on if I want to be sure.
- I'd disconnect the positive end of the low side of the relay.
- I'd attach it to a SPDT switch. Middle pin to the relay, side pin to the previous connection on the circuit board.
- The other side I'd connect a 12V input or whatever was measured. I'd use 8AA batteries or a 12V power supply, and 1k ohm resistor connected in series, and if that didn't work I'd try a couple other resistance values.
- So the switch would be normal operation in one position, and then always off or on in the other depending if my power supply is functioning.
all 22 comments