I have had problems with the drain plumbing downstream of my kitchen sink, because the heat causes the pipes to expand slightly and be longer. My theory is there is some loose wiring in the walls, and your drain pipes press on the loose wiring until they cool down again.
post
You’ve got an IR sensor somewhere that is supposed to turn the lights on when it senses a person’s presence. The heat from the boiling water is tripping sensor.
I have a similar sensor in my faucet. It always turns the faucet on when I pour boiling water into the sink.
That’s my guess anyway.
I have an led strip installed next to my oven at a similar place. There is a larger "button" that reacts to touch, you can also dim it. When I am cooking, the steam of the boiling water turns dims that light on and off, it's pretty annoying but also kind of funny.
Holy shit that sounds like a good setup to get electrocuted.
Please don't.
The number one rule of all electronics is thou shall check ground. Sounds like a grounding issue somewhere.
Is the sink stainless?
Do you have garbage disposal?
pic attached
I'm guessing you have an issue with your neutral loop and/or maybe a junction box fastener touching a water supply with a bad wiring job.
You can use a meter to get a better idea of what is happening, but I would suggest you seek a licensed electrician because this sort of issue could be indicative of a big dangerous problem.
I’m gonna guess the steam is causing a broken circuit connection in the led strip to briefly connect. This strips often have a thin wire running the full length of the strip and that can break when the strip is bent. If the steam is heating the strip it could be causing the wire to briefly expand, closing the small break and turning on the lights.
I suspect the vibrations of the pouring water are making something make contact with something else and that is turning on the LEDs.
Test this hypothesis with the same pot full of cold water.
When thee red bulbs in My under cabinet lighting are staring to die I have found the need to be tapped to turn on. I replace them and the new ones work fine.


all 21 comments