A few real life examples, all of which I'm in the middle of:

  • Fixing this closing mechanism for this box in the kitchen. A bit of trial and error to 3d print a replacement for this part that broke off.
  • Learning Rust. I got fluent in Perl in the previous century, and never quite got to that level with anything else. I figured it's time to pick up something more modern.
  • Sorting out my homelab/selfhost setup. The hardware is in place, but the software side isn't quite there yet.
  • The greywater vent goes up to the attic. I have started planning adding a vent and some more piping to place the endpoint outside, but it's probably not gonna be done until spring as it's cold as fuck these days.
  • Autopilot module for an RC aircraft, complete with altitude and attitude adjustments. Next up on the too list is navigating through waypoints. If budget allows I will build a plane around it next year.
  • Homebrewing a weather station door bell camera combination. Early planning stage.
you are viewing a single comment's thread
view the rest of the comments
[–] 5 points 14 hours ago

Just some art for a commissioner. Three out of five drawings in the sketching phase, going slowly because the character is kind of complex.

Other than that, I'm in the planning phases of getting another hard drive or two (owie my wallet) to make backups of almost three decades of files on my computer, because it scares the hell out of me that some freak event could happen and it would all be gone.

  • source