A few real life examples, all of which I'm in the middle of:

  • Fixing this closing mechanism for this box in the kitchen. A bit of trial and error to 3d print a replacement for this part that broke off.
  • Learning Rust. I got fluent in Perl in the previous century, and never quite got to that level with anything else. I figured it's time to pick up something more modern.
  • Sorting out my homelab/selfhost setup. The hardware is in place, but the software side isn't quite there yet.
  • The greywater vent goes up to the attic. I have started planning adding a vent and some more piping to place the endpoint outside, but it's probably not gonna be done until spring as it's cold as fuck these days.
  • Autopilot module for an RC aircraft, complete with altitude and attitude adjustments. Next up on the too list is navigating through waypoints. If budget allows I will build a plane around it next year.
  • Homebrewing a weather station door bell camera combination. Early planning stage.
you are viewing a single comment's thread
view the rest of the comments
[–] [S] 4 points 17 hours ago (1 child)

What scale are you looking at for the snow blower?

  • source
  • parent
  • hideshow 1 child comment
  • It's 450mm wide and 1m long targeting 6" of snow depth. Although it can probably do more. I have a test rig of the track system and getting ready to start test parts for the drive train.

    The project is 3 phases.

    First phase is a snowcat that is remote controlled. Second phase is a snowblower attachment, but still remote controlled. Third phase is automated.

  • source
  • parent