238
Built my own base station with blackjack, hookers, and the completely wrong hardware lmao (lemmy.dbzer0.com)
submitted 8 months ago by to c/meshtastic@mander.xyz
53 comments fedilink hide all child comments
 

Its a LILYGO T3S3 (a module focused on handheld use) stuck into a housing I modeled myself and 3d printed out of ASA plastic. It has some Chinese "high gain" 915MHz antenna inside the grain silo looking part, which is oversize to prevent too much signal reflection/distortion from the plastic being too close to the antenna. Its powered by 18ga alarm system wire that I draped down the roof to a 5v power supply on the deck. And since I'm renting, non permanent modifications only, thus the clamp to the vent pipe.

Its what I had, just to get started. Quickly realized I needed to be on my roof to get any good connections in my node-sparse area haha.

So far it's working well, I have 13 consistent mesh connections with 3 direct connections, when before I would previously only get spotty connections to the mesh at all from inside my house.

I'll buy some better base station hardware later, once I put one up at my girlfriend's house a few miles away....

you are viewing a single comment's thread
view the rest of the comments
[–] 2 points 8 months ago*

I usually direct people over to helteks because they are cheap and you can get 2 of them in the same box. For more info you can check out the official meshtastic site.

Or check out https://rootaccess.org/wiki/Meshtastic/rev447/#-quickstart

If you go with the defaults at least at first, you can see if its something you want to invest your time into. Worst case, you have a couple of these things you can give out to a couple of ham friends. You can go pretty deep with the hobby, but its fun (in my opinion).

  • permalink
  • fedilink
  • source
  • parent