I know this may be obvious to most in this community, but it saved me $1,000+ and wanted to let everyone know that it is in fact worth your time, effort, and hassle ordering the tools, watching or reading a quick tutorial or 2 and spending the time to clean you phone-s charging port.
you are viewing a single comment's thread
view the rest of the comments
[–] 3 points 1 year ago (5 children)

The port should detect shorts and stop working, atleast on waterproof phones

  • source
  • parent
  • hideshow 5 child comments
  • [–] 7 points 1 year ago* (4 children)

    Sure. But that's intended to detect shorts caused by water, and water is a much worse electrical conductor than a piece of metal, and so less damaging in the time it takes to detect a short.

    Even if phones have some level of protection, why risk damage when you could use something wooden or plastic and just not risk it at all?

  • source
  • parent
  • hideshow 4 child comments
  • [–] 5 points 1 year ago (1 child)

    Also, metal needles or equivalent can raise contacts and do their damage. I cut the toothpicks with a cutter so that they are wedge shaped.

  • source
  • parent
  • hideshow 1 child comment
  • [–] 1 point 1 year ago

    That is probably the correct way. But I just collect the dust at the bottom with the needle. Only plastic there. Sure, the side of the needle may come in contact with the pins, but it's round so not likeley to snag on a pin.

  • source
  • parent