I know this may be obvious to most in this community, but it saved me $1,000+ and wanted to let everyone know that it is in fact worth your time, effort, and hassle ordering the tools, watching or reading a quick tutorial or 2 and spending the time to clean you phone-s charging port.
you are viewing a single comment's thread
view the rest of the comments
[–] 17 points 1 year ago (8 children)

I use a toothpick as the metal could potentially short something

  • source
  • parent
  • hideshow 8 child comments
  • [–] 5 points 1 year ago*

    You’re not going to short anything.

    The power pins (VCC) on your phone’s USB-C port aren’t “live” at all times, the standard requires communication over CC1 and CC2 to negotiate which side is receiving power and at what voltage. Otherwise, a specific value of resistor needs to be in place between those pins and GND to get “dumb” charging at the original 5V usb standard.

    The ideal tool is going to be thin and rigid so that you can get to the base of the port and free up impacted dust/lint. Small enough plastics are going to be to flexible to be effective, anything too thick is going to increase the working time and risk putting pressure against the center tab, potentially damaging it.

    I fix consumer electronics for a living, my tool of choice is a pair of ultrasharp tweezers I use for microsoldering. Far as household items are concerned, a real small sewing needle is definitely it. The eye can even be used to catch and pull out fluff.

  • source
  • parent
  • [–] 3 points 1 year ago (5 children)

    The port should detect shorts and stop working, atleast on waterproof phones

  • source
  • parent
  • hideshow 5 child comments
  • [–] 7 points 1 year ago* (4 children)

    Sure. But that's intended to detect shorts caused by water, and water is a much worse electrical conductor than a piece of metal, and so less damaging in the time it takes to detect a short.

    Even if phones have some level of protection, why risk damage when you could use something wooden or plastic and just not risk it at all?

  • source
  • parent
  • hideshow 4 child comments
  • [–] 5 points 1 year ago (1 child)

    Also, metal needles or equivalent can raise contacts and do their damage. I cut the toothpicks with a cutter so that they are wedge shaped.

  • source
  • parent
  • hideshow 1 child comment
  • [–] 1 point 1 year ago

    That is probably the correct way. But I just collect the dust at the bottom with the needle. Only plastic there. Sure, the side of the needle may come in contact with the pins, but it's round so not likeley to snag on a pin.

  • source
  • parent