And the leg bone connected to the knee bone.
comments
USB can handle 127 daisy chained items. However, there's like an absolute maximum of the amount of data and power that can go over any one USB port.
Assuming this is USB 3, that would typically be capped somewhere around 5 gigabits per second and usually, 5 to 15 watts of power, so they would all have to divvy up that between themselves.
USB is pretty smart, so it probably won't automatically divide down based on the number of attached items like Wifi used to and instead the controllers should dole out the in-out requests on an as needed basis.
The USB port is attached to the motherboard.
Pot of Greed, Pot of Greed, Pot of Greed, I ASSEMBLE EXODIA. I WIN.
It's plugged into the USB port not the motherboard.
Would be a lot less cursed if they used a USBA extension so they could rest on a table.
This is art.
I imagine power is split evenly. I wonder if speed is split evenly or successively slower.
Me stacking my deck with 'Draw 2 cards' with no damage or money cards in my hand
Probably not a ton, the controller can handle a quite a bit. Really depends what you are doing with each cable. If all are transferring data to a separate thing on each cable then yes it could be bad. Power is more of the problem, only has so much juice per slot. If those are all phone charger cables, possible hardly any of them actually charging a device.
So does each successive one become slower or how does that work?
That's a Lenovo E480. There are two other USB-A and a USB-C and HDMI on the other side, plus you can't see behind the dongles but there's an ethernet port on the laptop as well.
I only have two complaints with what I'm looking at. One is there's probably not enough power for whatever you have connected to all of those USB things. And two, there's not enough support for the port that you're plugging this into to resist the weight of all of the dongles, which could damage the motherboard.
3000€, 1000 GB HDD, 32GB RAM, 15" screen, 1 port.
I hate laptop manufacturers.
Also rough if you got cats 🐈 🪮
Better than cable lacing 🤓
Honestly that works as well
Velcro is also reusable and removing it doesn't require sharp things around delicate and often pretty important cables.
I'd guess braiding is not that much more time consuming than fighting cables in a sleeve. Personally I'd use velcro-straps, but on our team there's always too little time to actually make things look decent, so pretty much all is in various stages of spaghetti, depending on which cabinet you're looking for.
If these are UTP, I demand a screenshot of cat /proc/net/dev and of some third party packet checking software that measures crosstalk and bit error. 😂
Or if you need to verify where each end is landed.
It's the wrapping of it around a ferrite core that does it. Surprisingly little can make a difference at certain clock rates. If you take a cat5 cable running 1G and loop it a dozen times in a 6" circle and put a metal screwdriver perpendicular to the loop in its center, you will see a spike in bit errors. Weaving one wire with another isn't going to be as strong of an effect, and it's fiendishly complicated in terms of an e/m problem, but it could easily be significant.
First read this as “it’s braindead.”
But you can cut a zip tie. This is terrible if you have to replace a cable.
That's fair. This is just my limited experience I'm speaking from, and I'm not the one buying the spools.
Get out! From the inductance? How long it a length of wire does it take for that to become an issue?