Anyone aware of a target date for when FreeCAD 1.0 and/or Ondsel 2024.3 will be released?

Background:

I'm coming from using onshape, looking for a local opensource alt. After researching freecad (and forks) it seems if I was to start learning now, I'm in for a significant shift in workflow when 1.0 releases.

In its current state I'd lean towards ondsel.

Kind of putting off the switch till one or both implement the topo naming fix, and the other major ui changes for mainline, so I don't need to learn two different workflows.

But I'm getting antsy and want to get learning soon.

 

Hello folks,

Does anyone here have experience smithing in a (rural) residential zone WRT noise levels?

I'm talking the 2-5 acre lot size "country residential" type area, not shoulder to shoulder subdivision.

Do you find you're generally able to smith indoors/outdoors during the daytime or did you need to do any special modifications for noise reduction to keep good relations with the neighbours? Soundproofing required?

I was originally planning on having a (covered) outdoor area for a forge. But we were looking at 20+ acres originally. An interesting lot has come up but its smaller (4 acres) and closer to neighbours so I'm trying to figure out if we'd need to change our blacksmithing plans. If outdoor isn't possible on these lot sizes without complaints then I'd need to pull permits for a structure which would be a bear to get approved for noise reasons I'd reckon