Its a slight tweak of the profile I use with other sunlu pla filament.
I've tried to top layer setting tweaking bit not luck so far
Hi,
I've just swapped to a new PLA (Sunlu wood filled) and I'm getting strange lines in my top layer.
It is like some areas are just not being extruded at all.
Any ideas how I go about finding the cause of this?
Thanks for the tip
Might have to save this as a last resort 😅
Thinks for the tips
There's a massive blob stuck round the thermistor wires that is detached from the hot end. Tried to melt the blob but cant get the middle to heat up.
If the wires do get broken are they easy to replace ?
Made a lot of progress but it is in the screwheads the attach the hot end. Ridiculous
Looks to be about £30 I think. Although looking at the service video I can't actually get to the screws to remove the hot end because they are covered in pla
Walked away from a print this morning and came back to a blob being dragged all over the printer.
The blob of pla was in and around the hot end sleave and just everywhere.
Is this salvageable or do I need a replacement hot end?
Printer is a creality k1
Thank you for linking. I have no idea how I didn't find it in my searches round printables!
Appreciate the help
Hey 3dprinting,
I'm trying to create something similar to the attached image, to hang hotwheels track, for a family member but I'm really struggling to find the dimensions of the underneath of the track.
Does anyone know of a marked up drawing or model that I could use?
Cheers
Ah ok. It can't do what I'm after then. I use Nova do that tap signal opens a specific contact chat and swiping opens it normally.
Can't find another laincher that can do that
Just downloaded Hyperion and trying to add gestures to apps but cannot see where.
Am I missing something obvious?
Don't you think the guy looks like MAGA Paul Hollywood?