Drilling and reaming the hole for the barrel. Just a Wen drill press and vevor positioning table, but the table isn’t really necessary just nice to have.

Not too worried about the hole being super straight as the end of an LCP barrel is belled out, so there is only a very small contact patch in a small location in the slide.

• Center drilled for a precise location
• 7mm drill for the pilot hole to depth
• 11.8mm drill bit for the hole to be slightly undersized
• 12mm reamer to size the hole. I ran it a couple extra times to hit 12.1mm measured on my stock LCP slide.

Again I forgot to take good pictures during operation.