21
MicroTimer - A weather station/clock that runs indefinitely on indoor solar power (imgur.com)
submitted 1 month ago by to c/diyelectronics@programming.dev
6 comments fedilink hide all child comments
 

https://github.com/yucandu/ClockV3

MCU

STM32L412K8T6

Display

ST7305 168×384 2.9" MiP LCD ("Memory LCD") @ 0.25hz

Sensors

AHT20 — Temperature & Humidity
BMP280 — Barometric Pressure
DS3231SN — Real-Time Clock
MAX17055 — Fuel Gauge

The AHT20, BMP280, and DS3231SN are powered directly from MCU GPIO pins to minimize standby power consumption.

Power System

30 mAh LiPo battery (Bluetooth earbud battery)
TP4054 charger configured for 50 mA charge current
DFM8001 energy harvesting module
Two 30 mm × 30 mm × 3 mm amorphous silicon solar panels
    Recycled from dollar-store garden lights

Runs at ~150uA avg, according to INA228 coulomb counter (used as poor man's power profiler). Sitting upside down on a desk in regular indoor lighting at night, solar panels harvest ~200uA. Coded entirely for STM32CubeIDE.

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 2 points 2 weeks ago

lol it's pretty simple, you just follow the instructions in the dfm8001 datasheet - SCRIN + GND to your solar panel, BAT + GND to your battery. Tie all three VFC pins to the BUCK pin to configure for lipo. Tie both MPPT pins to GND for a shitty solar panel. Tie L_EN, H_EN (unless you wanna use it instead of the RT9080), PRIM_U, PRIMBAT, and DCSC to GND. Leave all other pins floating. I think it's $6 on digikey.

  • permalink
  • fedilink
  • source
  • parent