63
rusty 3D printed walkway (lemmy.dbzer0.com)
submitted 3 months ago by to c/tabletopminis@lemmy.world
8 comments fedilink hide all child comments
 

First time trying to paint a thoroughly weathered/rusty piece, and also first time trying to paint 3D printed terrain.

Printed with a 0.2mm layer height, it was surprisingly annoying to paint compared to regular cast HIPS pieces. Washes are completely useless, or at least behave very differently, due to capillary effect of the layer lines.

I think I went a little too heavy with the rust orange color so it lost some definition. It looks a little more defined IRL than the photo shows.

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 4 points 3 months ago

Here's another piece from the same artist (terrain4print). I tried using metallic silver as the base for most of the panels on this one, and the adding the rust and grime in top of that. I finished it with a dark tone wash on the silver panels because it was still a bit too shiny. Turned out pretty good i would say.

  • permalink
  • fedilink
  • source
    •