Documentation file complete. Going to test it and then if it works send it off to sail. Uses two spring loaded plungers installed into the side of the receiver using JB Weld'd threaded inserts. Any one see why this might not work?
-- sleepy echidna
Theres a ball bearing detent delayed ump called the holdup i tried. The detents were threaded on the outside to allow for adjustment without having to reprint the entire frame like you'd have to were they secured in cups. Its a viable idea HOWEVER theres a serious issue with inconsistencies between individual detents from amazon. the detents i bought had tension inconsistencies between ones from the same package if that gives you in idea of what you may get from amazon. they also wouldn't last longer than a few hundred rounds before the ball bearing would pop out and cause the bolt to wedge itself immobile. dont cheap out on these if you decide to try this