I've printed hundreds of prints over a few years. Now I haven't printed in a few weeks but this is the first time I've had a problem like this. This is supposed to be flat. What's happening?
Bonus video: https://drive.proton.me/urls/74XZH4FVSM#1QqSvXK3MJCF
The audio might be a clue for you to help me troubleshoot
Yeah I’m no expert, but this looks like extrution issue to me too.
My H2S looked similar in one corner, as the bowden tube from the factory is a tad bit to short, so the feed was uneven when it was curved/stretched to the max.
Replaced it with a 3 cm longer one, and it worked fine again.
I’d try a cold pull, then smaller test pieces. No point printing the whole bed when the issues are everywhere. When it’s nice, test the whole plate.
Good luck!