I spent two weeks getting this inherited Massey Ferguson running in order to dig up the front garden I have (also herited) in order to plant roses for my late mother's memory.

you are viewing a single comment's thread
view the rest of the comments
[–] 17 points 7 months ago* (6 children)

That's pretty neat. I'd have probably modified the knuckle for something current or replaced the entire axle before I'd have even thought of trying to build a ball joint. I've replaced them dozens of times, but I've never cut one apart to see if I could make one.

  • source
  • parent
  • hideshow 6 child comments
  • [–] [S] 20 points 7 months ago (5 children)

    I have a dull past of 20 years as a machinist, so it makes me think that way.

  • source
  • parent
  • hideshow 5 child comments
  • [–] 12 points 7 months ago (4 children)

    So, a question then: why use a set degree chamfer tool instead of the compound slide to taper it? I've built a few specialty things but I can't say I've tried to run off a taper, though I understand the concept, so I may have no clue what I'm talking about.

  • source
  • parent
  • hideshow 4 child comments
  • [–] [S] 14 points 7 months ago (2 children)

    Honestly, it is because I had it on hand and it was fast. 0.5 degrees wasn't going to matter here since it simply needs to fit and the whole weight of the engine will force it in place.

  • source
  • parent
  • hideshow 2 child comments