Previous handle was a pimple on a 2 way screw (no idea what these are called or how it was still holding on) so replaced it with one on 4 bolts on washers for a better grip.

After taking it off it appears that the screw was "sealed" in some sort of wood filler.

A new shed handle
you are viewing a single comment's thread
view the rest of the comments
[–] 19 points 9 months ago (10 children)

Nice job!

The bolts you used are called "carriage bolts". They have a square "neck" under the round head to give them grip once they get into the wood.

You may want to make a square slit in the handle plate so the head is flushed.

  • source
  • hideshow 10 child comments
  • [–] [S] 6 points 9 months ago (7 children)

    Thanks for the tip, it does look a bit odd that those bolts are peeking out a little, but don't think i have a tool for doing that (out of interest what do you normally use to do it?) to the metal handle. If i have something to use for it il do it :)

  • source
  • parent
  • hideshow 7 child comments
  • [–] 2 points 9 months ago (3 children)

    Depending on the metal you may be able to just broach it with the bolt itself.

  • source
  • parent
  • hideshow 3 child comments
  • [–] 3 points 9 months ago (1 child)

    Assschually the square bit is for a square hole in metal plate, not the wood itself, so you dont have to hold the other end when tightening the but.

    That being said ive misused them all kinds of ways

  • source
  • parent
  • hideshow 1 child comment