you are viewing a single comment's thread
view the rest of the comments
[–] 4 points 11 months ago*

Things that have worked for me:

  • your bed is probably not level, i installed self leveling on mine ($30 but well worth it)

  • if its adhesion, try a glue stick. It looks like a PEI sheet but that alone was not enough for me. My routine is: wash with soap and water, spray 90+% IPA (before bed is heated) and wipe with microfiber (paper towel leaves flakes behind), then apply gluestick before printing

  • maybe check your bed is warm enough/preheat for longer to allow the whole bed to get to temp, though i doubt this is the case but it doesn't hurt to try

  • for your first layer: slower speed, higher nozzle temp, higher bed temp

  • source