50
I bought an Ender 3 V3 (corexz) recently, and have been having bed adhesion issues. Please help me interpret this bed adhesion test result (programming.dev)
submitted 11 months ago by to c/3dprinting@lemmy.world
28 comments fedilink hide all child comments
 

This is the model I used: https://www.thingiverse.com/thing:4572809

I printed these by using the official orca profile from Creality for Orca Slicer: https://wiki.creality.com/en/ender-series/ender-3-v3/quick-start-guide/how-to-use-orca-slicer-with-ender-3-v3

  1. Why are the squares looking so wonky? Which setting is responsible for this?
  2. I see some spots where the prints moved to other places, but I run bed leveling every time. Is it bed warp, or some other profile setting I need to tweak? I wiped the bed with 70% isopropyl alcohol before I printed this, btw

EDIT:

Looks like the issue was with the wobbly table. I placed it on the floor, reran the self tests, and it's now printing a lot better!

you are viewing a single comment's thread
view the rest of the comments
[–] 5 points 11 months ago

I think its a bit excessive. That shows there's almost a two and a half layer (at a standard 0.2mm layer) difference between the high and low spots. On my old printer with klipper installed, I would shoot for less than 0.2mm.

  • permalink
  • fedilink
  • source
  • parent