75
Lacking the original hardware, how would you attach this table leg? (lemmy.world)
submitted 11 months ago by to c/woodworking@lemmy.ca
23 comments fedilink hide all child comments
 

I found this table on the curb a while back, less the leg hardware. No a relative could use it, and I'm wondering how to fix it up.

Cut a couple 2x4 sections to fill the truncated-triangular area and screw through them into all surfaces?

The legs have a hollow center drilled out, at the top, so I assume some metal piece with threaded holes fit there, and a metal plate anchored that to the skirt (?).

Another view:

you are viewing a single comment's thread
view the rest of the comments
[–] 15 points 11 months ago (3 children)

This is the best answer. If you are going to go with @dohpaz42@lemmy.world approach, just make sure to use a paddle bit to hog out the inset and use a washer so you can crank the bolts all the way.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 3 child comments
    •