85
Designed & printed a bracket to mount wheels on my hammock! (lemmy.today)
submitted 1 year ago by to c/3dprinting@lemmy.world
12 comments fedilink hide all child comments
 

I wanted to add wheels to my hammock so I could easily move it into shade throughout the day. Some openscad later and came up with this little bracket. Uses a clevis pin for an axle, and just pops into the metal tube feet of the hammock. 3d printed bracket to hold an axle

Here's the files on printables

you are viewing a single comment's thread
view the rest of the comments
[–] 9 points 1 year ago* (5 children)

I was about to ask whether you were one of those to set up a printing-gantry in the garage for that extra print volume until I realized you were only talking about the wheels.

Is that PLA, or something else?

Have you done any stress testing to see how much load the can handle?

EDIT: Oh, and wouldn't it make more sense to print it in its side?

  • permalink
  • fedilink
  • source
  • hideshow 5 child comments
    •
  • [–] [S] 7 points 1 year ago (2 children)

    Haha, this was just printed on my voron. Although a giant garage printer would be pretty cool.

    I printed this in ASA to help with the heat. No scientific stress testing but I've been using it for a week or so without issue. And with this print orientation it should be strong enough, since the forces are perpendicular to the layer lines. If it does break, the hammock would drop maybe an inch so I'm not worried.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •