My rpi has been really loud with its fan for the last long while. I could still hear it behind a cupboard and a door. While diagnosing a usb thumb drive's i/o issue, I decided to dampen the sound.

Using 6 roofing screws, I pulled the rubber and metal washers off and put on the fan mounts to the case. It has had the effect of increasing the mass of the case and reduced the sound in pitch and volume, I expect the lower pitch will be easier to muffle.

It is much less annoying.

The washers were a bit larger than the fan mount plastic sockets. I did not try to force it to sandwich between the fan and the case.

all 6 comments

sorted by: hot top controversial new old
[–] [S] 4 points 6 months ago
[–] 3 points 6 months ago (2 children)

If you don't launch heavy tasks, you can plug your fan on the 3V pin instead of the 5 V pin. That's what I have done and it's working great so far.

  • source
  • hideshow 2 child comments
  • [–] [S] 2 points 6 months ago (1 child)

    So I looked into it:

    I have a 2 prong connected power source, A 1 prong needs to be in ground, and the only pins with power and adjacent to ground is 5v.

    There are some options with getting a mofset and control by gpio or splitting the sockets but I didnt want to add scope creep

  • source
  • parent
  • hideshow 1 child comment
  • [–] 3 points 6 months ago (1 child)

    A Flirc case works well too.

  • source
  • hideshow 1 child comment