6
Specifications for 15mm Launchers (forum.guncadindex.com)
submitted 4 months ago by to c/general@forum.guncadindex.com
6 comments fedilink hide all child comments
 

I've been starting work on a couple 15mm launcher projects but can't seem to find any specifications to help with design. The biggest thing I'm missing at the moment is the twist rate for the rifling. I could technically just use booleans from existing releases but would much rather have some more control over the geometry. Anyone have the specs?

you are viewing a single comment's thread
view the rest of the comments
[–] 1 point 4 months ago

Tbh if I were you I'd make a projectile specific to the barrel you end up with using boolean cuts to eliminate the headache of recreating pre-existing stuff. Or you could always just use the existing screw on 15 barrels originally used on the pen15

  • permalink
  • fedilink
  • source
  • parent