I've been working on Ben Eater's breadboard 6502 computer project for a little while. The pins on the EEPROM sometimes get bent when I pry it out of the breadboard to reprogram it. I was afraid that they'd break eventually, so I looked into getting a Zero Insertion Force (ZIF) socket to put on the board, which should be gentler on the EEPROM's pins. Ran into a few problems though:

• The pins on ZIF sockets are too short to seat properly on a breadboard. They're designed to be soldered into a printed circuit board.
• I found a few designs for adapter PCBs that allow a ZIF socket to be used on a breadboard. They're all sized for the common green ZIF sockets, which take up a lot of extra space compared to the chip that they hold.
• Aries Electronics makes low-profile ZIF sockets that are very compact, but I couldn't find any adapters designed for them.

I eventually decided to solve that last one myself, and I figured I'd share the design in case anyone else might find it useful: