Needed to replace the coals in the motor.

you are viewing a single comment's thread
view the rest of the comments
[–] 20 points 1 year ago (11 children)
  • [–] 31 points 1 year ago (8 children)

    Motor brush. Its a chunk of carbon that makes contact with a bit on the motor shaft.

  • source
  • parent
  • hideshow 8 child comments
  • [–] 21 points 1 year ago (7 children)

    Hol up. Do most washers use brushed DC motors??? Why? That's such a strange choice of motor for that application.

  • source
  • parent
  • hideshow 7 child comments
  • [–] 14 points 1 year ago (4 children)

    Older front loaders i think. The speed and direction control is much simpler compared to modern BLDC.

  • source
  • parent
  • hideshow 4 child comments
  • [–] 4 points 1 year ago*

    I assumed they would just use capacitor commutated AC motors like most 'dumb' motors running on single phase.

    I also assumed during the wash cycle it would just switch direction before the motor could accelerate to full speed, then the spin cycle was full speed. I didn't realize any more speed control was necessary.

  • source
  • parent
  • [–] 1 point 1 year ago

    I've done the same on our front loader. Though top loading machines are the exception rather than the norm here.

    Hardest part of the job is just shifting the machine to get access. Once you're in, it's 5 minutes to swap them out and another 5 to scrub your hands after, because I'm an idiot that forgets gloves 🙃

  • source
  • parent