The output of the audio amp is a voltage waveform. You can think of voltage as a force that pushes on charges.
In order for the speaker to make sound, you must pass a current through it. Current is the speed the charges move.
I personally don't like the water/pipe metaphor, so instead think of the charge as a car that you're pushing.
If the car is on pavement (low resistance), a force (voltage) applied to it will get it moving at a good clip. Imagine you're the audio amp here and you can feel the pressure on your hands as you push the car at a walking pace.
Now apply that same amount of pressure while the car is stuck in sand. You might imagine you're moving a lot slower.
So for a fixed voltage, higher resistance (sand), means less current (speed).
Now imagine the car is on Teflon skids and just had its bearings lubricated so well that a light push with a pinky is all that's required to achieve the walking pace from before. If you attempt to apply the same amount of force with your hands as before, you will find yourself running and struggling to keep up. In fact, you may find the car moving so fast that you can't even maintain the pressure with your hands.
That pressure x your speed is the power output of your amp. A lower resistance speaker requires a higher power amp that can maintain a higher current without dropping voltage. If voltage drops, the audio waveform will get distorted.
Now bear in mind that speaker resistance is really an impedance that only affects AC waveforms, but for this discussion, we can ignore that.
