11
My old 1-channel relay driver circuit works (lemmy.ml)
submitted 1 day ago by to c/askelectronics@discuss.tchncs.de
11 comments fedilink hide all child comments
 

so i have shared the it's schematic and board design with the eevblog.com community and they said "that this module will not work and the relay contacts and board tracks can't handle high current" I improved and made the board anyway and tested it with inductive and resistive loads and it works without a problem huh

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 1 point 19 hours ago* (2 children)

I already added solder to the relay contact tracks to increase it's thickness

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 2 points 6 hours ago (1 child)

    Looks fine. Mayyyyyyybe the 1k resistor is a little high, depends on the gain of the transistor. 5 volts would feed it with 5mA on its base, which might not be enough to fully switch it on. However, as it's only driving the relatively high resistance coil in the relay it's nothing to worry about if it works.

    If you were driving it with 3.3V, I'd probably swap that transistor out for a Darlington pair to make sure the gain is high enough to fully switch on at that kind of drive voltage. You can get Darlington pairs in the same pinout as normal transistors so it would be a straight swap on the board.

    Having said all that, if it's working in your application, leave it. 🤷

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •