200
A cabin in North Cascades National Park wrapped in a protective foil to prevent it burning down from a forest fire. (lemmy.today)
submitted 3 months ago by to c/interestingasfuck@lemmy.world
37 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] 7 points 3 months ago (1 child)

I've no idea what temperature mylar fails at, but I wouldn't be surprised if it's lower than that of a full throttle forest fire.

Typically meant for 300F and below. Melts at just a bit below 500F. Forest fires are several times that temp (like 1600F to 2000F).

This isnt mylar though, mentioned elsewhere its called aluminized structure wrap.

Aside from some of the basics I mentioned about it though, I have no direct experience using it. It was discussed in FF training.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •
  • [–] 1 point 3 months ago

    My first guess was that the reflective surface would act as a thermal barrier against ambient temperature. If that's just the outer layer it may have some actual insulation built-in too. Considering the use-case it'd be reasonable to engineer for an increased tolerance to some hazard whose benefit compounds alongside other precaution and prep.

    i.e. the protective material's melt point only has to be a bit higher than the shielded material's flash point for the product to be effective as-advertised. It won't save the cabin if ambient temp hits ignition or combustion temp but the cost:benefit may still make sense.

    Searching for "aluminized structure wrap" provides some results which seem to confirm this.

    What was the context of your discussion during firefighting training? Accurate to the marketing copy? Less situationally useful than advertised but still better than nothing? Completely worthless?

  • permalink
  • fedilink
  • source
  • parent